* Common household spray bottle
* Good ruler-scale big business for big windows
* Baby shampoo, Johnson & Johnson works great!
* bottled water the best
* cloth (or coffee filter)-microfiber cloths are good
* cloth (or coffee filter)-microfiber cloths are good
...Planning for the installation of
Planning for the installation of
...Measure and record the length and width of each window that you want to add a movie. You will want to know the measurements first to determine which size to buy. You should add 10-20 percent to account for the purchase of the error, and any additional debris.
...application
...application
...application
...2 Using the measurements you recorded, cut the first piece of film "wider and 1" longer than the window you intend to install.
...3 Spray the window, using a spray bottle with a solution of baby shampoo that you use to clean windows. Keep your hands moistened in the solution is also to prevent leaving fingerprints. Do not be afraid to spray generously, it is better to have more water than not enough at the window.
...4 Use two pieces of transparent tape to remove the support from the film. Basically, you put the tape on each side at the corner of the window and pull the foil strip cards, except that it can be detached from its support. Once you are exposed to an inch or so of the film support, spray it down with a soapy solution. For large pieces, you will need a helper to spray while you peel the film to give it from contamination.
...6 Use a sharp utility knife along with his straight edge placed along the edge of the window to cut the film. Leave 1/16 "border between the edge of the film and the window.
7 After most of the excess window film is trimmed off, go ahead and re-spray the surface film and sponge out any bubbles. Air bubbles will have to be made towards the edge of the glass and should be able to escape through the 1/16 "space between the film and the edge of the window.
7 After most of the excess window film is trimmed off, go ahead and re-spray the surface film and sponge out any bubbles. Air bubbles will have to be made towards the edge of the glass and should be able to escape through the 1/16 "space between the film and the edge of the window.
...
No comments:
Post a Comment